Replace Your 2016 Dodge Charger Drive Shaft Center Bearing with Ease and Confidence

Is your 2016 Dodge Charger making a clunking or rumbling noise when you accelerate or decelerate? It might be time to replace your drive shaft center bearing. This essential component supports the drive shaft and keeps it from wobbling, which can cause a variety of problems.

Replacing the center bearing is a relatively simple repair that can be completed in a few hours with the right tools and knowledge. Here's a guide to help you through the process:

Benefits of Replacing Your 2016 Dodge Charger Drive Shaft Center Bearing

Improved performance: A new center bearing will reduce noise and vibration, and improve the overall performance of your Charger.

Extended lifespan: Replacing the center bearing can help to extend the lifespan of your drive shaft and other related components.

Safety: A worn center bearing can cause the drive shaft to fail, which can lead to a loss of power and control. Replacing the bearing can help to prevent this from happening.

How to Replace Your 2016 Dodge Charger Drive Shaft Center Bearing

Replacing the center bearing on a 2016 Dodge Charger is a relatively simple task that can be completed in a few hours. Here's a step-by-step guide:

Gather your tools and materials. You will need:
- A new drive shaft center bearing
- A socket wrench
- A torque wrench
- A pry bar
- Safety glasses
- Gloves

Safety first! Park your Charger on a level surface and engage the parking brake. Put on your safety glasses and gloves.

Locate the drive shaft center bearing. It is located in the middle of the drive shaft, between the transmission and the rear axle.

Remove the bolts that hold the center bearing in place. Use a socket wrench to loosen the bolts, then remove them by hand.

Remove the old center bearing. Once the bolts are removed, you can pull the old center bearing off the drive shaft.

Install the new center bearing. Place the new center bearing on the drive shaft and align it with the holes in the bearing housing.

Tighten the bolts. Use a torque wrench to tighten the bolts to the specified torque.

Reconnect the driveshaft. Slide the driveshaft back into place and reconnect it to the transmission and rear axle.

Test drive your Charger. Once the center bearing is replaced, take your Charger for a test drive to make sure it is operating properly.

Additional Tips

If you are not comfortable replacing the center bearing yourself, you can take your Charger to a mechanic.

The cost of replacing the center bearing will vary depending on the make and model of your Charger, as well as the cost of labor in your area.

Replacing the center bearing is a relatively simple repair, but it is important to follow the steps carefully to avoid damaging your Charger.

Common Mistakes to Avoid When Replacing Your 2016 Dodge Charger Drive Shaft Center Bearing

Using the wrong size bearing: Make sure you purchase the correct size center bearing for your 2016 Dodge Charger. Using the wrong size bearing can cause damage to the drive shaft or other components.

Not tightening the bolts properly: It is important to tighten the bolts that hold the center bearing in place to the specified torque. Overtightening the bolts can damage the bearing, while undertightening the bolts can cause the bearing to come loose.

Not aligning the bearing properly: The center bearing must be aligned properly with the holes in the bearing housing. If the bearing is not aligned properly, it can cause vibration and noise.

Conclusion

Replacing the drive shaft center bearing on a 2016 Dodge Charger is a relatively simple repair that can be completed in a few hours with the right tools and knowledge. By following the steps in this guide, you can save yourself the cost of having a mechanic do the repair.

Replace Your 2016 Dodge Charger Drive Shaft Center Bearing with Ease and Confidence